|
Data Read |
Measured data saved in the device are read in the personal computer.
Data No., minimum level values, recorded date and time, filter set (high-pass
filter/low-pass filter/notch filter), noise reduction level, and flag can
be obtained.
Reading saved data in device
1. Turn ON the device, and connect the device to the personal computer
by the USB cable.
2. To read the measured data, select "Device Edit" > "Data
Read" from the menu.The "In communications" message is displayed, prompting you
to verify that the device is securely connected to the personal computer.

>When communication cannot be carried out:
3. After data read is normally completed, the dialogue is displayed, indicating
that measured data are properly saved. A list of data No., minimum level
value, recorded date and time, and flag of the acquired data is displayed.

Data search refinement |
Select either data No. or recorded date and time and search data for refinement, and the list is re-displayed. |
Graph display |
Selected data are displayed with graphs. |
Re-read |
Data read from the device is carried out again. |
Close |
The "Saved data" dialogue is closed. |
Note: Even though the dialogue (to display saved data) is always displayed in the front line as the top priority, data edit can be carried out on the graph window.
Note: Once you close the dialogue, data that is not graph-displayed will be lost. Re-reading should be tried as needed.
4. Select graph-displayed data (one or more) from the list and press the
"Graph Display" button, and selected data is (or are) displayed
on the Graph window.
Note: Number of graph-displayed data: up to 250

|
|
|